Fixed a bug in v1.0.42 that made show-to-show cross fade stop working.
Added Info->View Alarms menu item to user interface.
Fixed several issues related to Alarms based on Astronomical Clock values.
Fixed a bug that causes a brief flicker at the end of a downloaded show set to loop, when the iP3 brightness is less than 100%.
Fixed bug in day-of-week calculation that caused alarms configured to fire on a particular day of the week to fire on the wrong day.
Fixed problem that caused freshly-formatted SD cards to cause Error Code 3 and Error Code 7.
Made some speed improvements in USB download.
Should use with iP3USBLib v1.0.21 and above for maximum effect.
Added load-leveling code to reduce excessive SD card writes.
Fixed bug that caused long shows to eventually slow down.
Extended DMX "Break" duration to match spec.
Fixed menu bug that occurred whenever a user chose "No" at the "Save Changes" prompt inside the "Triggers" submenu.
Fixed subtle bug in "Set Relative Brightness" expansion port command implementation.
Fixed DMX bug that caused occasional empty frames (with only Break, then Mark, then Start Code, but no data) to be generated).
Added ability to send arbitrary DMX frames via USB in order to facilitate creation of tools like SAS and PDSTool for iPlayer3.
Fixed bug that required a power cycle (due to Alarm Error) after powering up an iPlayer3 with a freshly-formatted SD card in it.
Fixed the "Error Code 3" file corruption bug caused by excessive SD card sector wear.
Fixed onboard user interface bug that capped "seconds" fields at a value of 58.
Fixed problem with expansion port command response strings.
Fixed bug that prevented users from clearing an alarm from the onboard UI.